High quality customized size water supply and drainage plastic pipe
PE water supply and drainage hot melt butt joint steps
1. Put in the PE pipe to be welded, fasten the fixture, and adjust the amount of misalignment
2. Put in the port milling cutter to correct the port plane until continuous chips are formed, take out the milling cutter and adjust it again to check the coaxiality
3. Put the preheated heating plate into the middle of the rack, and close the port for port heating
4. take out the heating plate after absorbing heat within the specified time
5. Quickly close the fixture, close the PE water supply pipe to be welded, and steadily increase the pressure
6. Keep the pressure until the interface part cools and reduce the pressure to zero, then loosen the clamp to take out the pipe and complete the welding.
HDPE Water Supply Pipes
Straight Hdpe Pipe For Water Supply
HDPE Plastic Composite Pipe
4 Inch HDPE Water Supply Pipes